P06BF BMW Fault Code
Check P06BF OBD Fault Code ReasonOutput Shaft Speed sensor circuit intermittent failure The output shaft speed sensor signal to the PCM is irregular or interrupted.
Harness connector not properly seated Harness intermittently shorted, or open Harness connector damaged OSS sensor damaged, or not installed properly Verify harness and connector integrity Verify OSS sensor proper installation.
P06BF Code Symptoms :
The original multi-displacement system turned off opposite pairs of cylinders, allowing the engine to have three different configurations and displacements. P06BF code had an elaborate diagnostics procedure, including showing engine trouble codes on the air conditionning display. However, the system was troublesome, misunderstood by customers, and a rash of unpredictable failures led to the technology being quickly retired.
Diagnosis And Repairing P06BF
P06BF OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.
How to fix P06BF code ?
- EVAP system hose leaking
- Continuous oil flow to the VCT piston chamber
- Erratic camshaft position due to low oil pressure
- Oil Control Valve (OCV) circuit is open or shorted
Gear changes are accomplished by a command from the BMW TCM to energize the clutch actuator to release the clutch; after which various actuators inside the transmission disengage the current gear, and depending on current operating conditions, engage the next higher or lower gear ratio. All of this happens much faster than a human driver could change gears, and in most applications, gear changes are as smooth and seamless as on any fully automatic transmission.
